CERTIFICATION & QA
Certifications / Inspections / Quality Control / Technical
Our qualified and experienced engineers and technical team can carry out the following tests and inspections at our facility, few of them can be done at a third party facility strictly under our quality control.
Alternators
Air Gap Inspection and Megger Test
Cylinder Liners
Inspection, Bore Calibration and DPT
Cylinder Heads
Inspection, Hydraulic Pressure Test, MPI / DPT on Combustion Space
Aux Engines, Compressors, Purifiers and Heat Exchangers
Complete Overhauling, Servicing and Load Test
Piston Crowns
Inspection, Groove Height Measurements, Groove Axial Clearance and DPT on Combustion Space
Crankshafts
Inspection by Pin Diameter Calibration, Trueness Check, MPI, DPT & Hardness Test
Connecting Rods and Piston Rods
Inspection, Calibration, Band Test, MPI Test on Serration teeth, Hardness Test / DPT on Piston Rods
Aux Engine Block
Inspection with MPI and DPT
Aux Engine Bedplate / Crankcase
Inspection, Main Bearing Housing Measurements, Laser Alignments, MPI and DPT
Fuel Pumps and Injectors
Servicing and Pressure Setting
Camshaft
Inspection with Calibration Report
Turbo Charger
Servicing Including the Rotor Shaft Dynamic Balancing